Preliminary Evaluation · Closed
Front Subframe Corrosion
Manufacturer: Mazda Motor Corp.
This investigation led to a recall
NHTSA links this probe to recall campaign 18V631000.
Read the recall: what is defective and the free fix →What NHTSA is examining
In a letter dated September 14, 2018, Mazda North American Operations (Mazda) notified the National Highway Traffic Safety Administration (NHTSA) of a defect in the front subframe assemblies of model year (MY) 2009 through 2010 Mazda6 vehicles in certain states with high road salt use in winter months (Recall 18V-631). The recall covers approximately 48,814 vehicles that were sold or ever registered in the following states and District of Columbia:Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, and Wisconsin. Mazda indicated that the recalled vehicles may have insufficient paint coating on the front cross member, which after continuous use in salt states may cause premature corrosion of the cross member. As the corrosion progresses over time, the structural integrity of the mounting point at the passenger side of the lower control arm may deteriorate and cause the steering alignment to change. If the steering alignment changes significantly while the vehicle is in motion this may increase the risk of a vehicle crash.ODI's analysis of complaints it has received from the public (VOQ's) and Mazda complaint data submitted in response to the information request letter for PE18-006 identified a total of 53 non-duplicative reports alleging incidents in which front cross-member corrosion had progressed to…
Vehicles under investigation
Source: NHTSA Office of Defects Investigation records, updated daily. An investigation is not a determination that a defect exists; many probes close without a recall.