Failing 5th wheel attachment bolts

What NHTSA is examining

On October 3rd 2010 the Office of Defects Investigation (ODI) received two complaints on 2009 - 2010 Mack CXU612 and CXU trucks for failing bolts that clamp the 5th wheel to the frame of the truck. On January 19, 2011 ODI opened this Preliminary Evaluation.During the course of the investigation ODI took possession of fasteners from the field.These fasteners, taken off subject complaint vehicles, exhibited 'hourglass like stretching' indicating plastic deformation.This same source supplied ODI with new fasteners (for the subject vehicle) that were recently purchased and never used.The bolts supplied by the manufacturer are M16 x 2 Class 10.9 bolts.Per SAE J1199, these bolts should have a proof load 130 kN (~29,000 lbf) and tensile strength of 163 kN (~36,600 lbf).These bolts are not designed to be torque to yield.ODI took possession of these field samples and sent them to (VRTC) Vehicle Research and Testing Center for testing.Some of the new and used fasteners from the field were tested to the SAE J1199 standard and all passed.Other tests at VRTC indicated that the stretched bolts were likely the result of over torque during installation or maintenance.VRTC tested other methods to pre-tension the bolts and found that load indicating washers and turn-of-the-nut method both gave better clamping load control than a torque wrench.In February 2011 Mack started to perform field inspections associated with this investigation in an attempt to understand the cause of the bolt…

Vehicles under investigation