Friday, August 7, 2026
RecallGazette

Vehicle problems, recalls & safety intelligence

Preliminary Evaluation · Closed

ENGINE STALLING - FUEL PUMP FAILURE

Action number
PE08044
Opened
Jul 17, 2008
Closed
Sep 3, 2008
Outcome
Recall 08V429000

Manufacturer: Hyundai Motor America

This investigation led to a recall

NHTSA links this probe to recall campaign 08V429000.

Read the recall: what is defective and the free fix →

What NHTSA is examining

On august 19, 2008, hyundai submitted a defect information report to nhtsa concerning fuel pump failure resulting in engine stall in approximately 65,000 model year 2008 hyundai elantra vehicles with 2.0 liter beta engines produced from november 5, 2007, through june 28, 2008 (nhtsa recall no. 08v-429, hyundai campaign 086).the recalled vehicles are equipped with fuel pumps manufactured with upper body components from a different supplier than those manufactured prior to november 5, 2007.according to hyundai, the new supplier's upper body components had incorrect dimensional characteristics resulting in misalignment of the armature shaft, which caused some of the fuel pumps to experience poor brush-to-commentator contact conditions that could result in engine stall. The use of ethanol blend fuel, containing up to 10 percent ethanol, causes a film build-up that creates high resistance between the brush and commutator.the misaligned armature shaft prevents the brush and commutator from making sufficient contact to overcome the high resistance film build-up, therefore producing less pumping pressure than required to supply the fuel injection system. Sixty-four of the complaints (72%), including the crash and injury allegation, involve the recalled vehicles.the complaint rate in the subject vehicle population is 98.5 per 100,000 vehicles, compared with 21.4 in the remaining population, which has on average been in service over a year longer.the warranty claim rate is also…

Vehicles under investigation

Source: NHTSA Office of Defects Investigation records, updated daily. An investigation is not a determination that a defect exists; many probes close without a recall.