Friday, August 7, 2026
RecallGazette

Vehicle problems, recalls & safety intelligence

Investigation · Closed

Trans/Air TA73 Evaporator Melting

Action number
EQ10009
Opened
Dec 7, 2010
Closed
Mar 14, 2011
Outcome
Recall 11V091000

Manufacturer: Trans-Air Manufacturing Corp.

This investigation led to a recall

NHTSA links this probe to recall campaign 11V091000.

Read the recall: what is defective and the free fix →

What NHTSA is examining

On June 22, 2010, Trans/Air Manufacturing (Trans/Air) reported that it had decided certain TA73 evaporators, manufactured between August 2, 1999, and May 15, 2007, contain a safety related defect.Trans/Air reported that these evaporators contain a power resistor to regulate blower speed.Should a short occur in the low or medium speed circuit while the blower is in high speed, the short may cause the resistor to melt and possibly ignite the plastic blower housing to which it is mounted.A melted blower housing could result in a fire.This issue was assigned recall number 10E-028.On December 8, 2010, the Recall Management Division (RMD) mailed Information Request (IR) letters to 7 vehicle manufacturers on Trans/Air's customer list.All 7 manufacturers responded to RMD's IR letter.Glaval Bus had filed their subsequent Defect Report before receiving RMD's IR letter and it was given recall number 10V-618.It was discovered that Coachmen RV's bus assets were purchased by a company called All American Group.After research with Trans/Air, All American Group discovered that no past Coachmen units were affected and they were accidentally included on Trans/Air's customer list.Trolley Enterprises responded that they had gone out of business in July 2010.Previous employees are presently searching for any remaining customer records and will forward them to RMD if recovered.The following Defect Reports were received as a result of this EQ:10V-637 - Micro Bird School Buses 10V-645 - Micro Bird…

Vehicles under investigation

Trans/air TA73

Source: NHTSA Office of Defects Investigation records, updated daily. An investigation is not a determination that a defect exists; many probes close without a recall.